E8SA-150A-TA

Features

  • Fast Acting fuse for DC Application
  • 800Vdc ideal for EV or HEV application
  • Stud-mount, optional for other installation
  • Reliability performance design refer to ISO8820-8&GB/T31465.6
  • Excellent DC performance
  • Design to EV fuse standard UL248-20
  • Comply RoHS directive

 Specifications

Part Number Rated Current (A) Rated Voltage (Vdc) Breaking Capacity (A) I2t (A2S) Power Loss At 0.5In (W)
Pre-arc Total @1000Vdc
E8SA-100A-TA 100 800 50000 1750 10500 3.3
E8SA-125A-TA 125 800 50000 2450 14930 4.3
E8SA-150A-TA 150 800 50000 4300 26260 4.8
E8SA-160A-TA 160 800 50000 5200 31720 5.3
E8SA-200A-TA 200 800 50000 10910 54760 6.5

Dimension (mm)

E8SA-150A-TA

Note: Recommend tightening torque is 12+/-1.0Nm (M8)

Temperature Re-Rating Curve

E8SA-150A-TA

Operating Temperature: -40°C to +100°C, with proper rerating factor applied

 Time-Current Curve

E8SA-150A-TA

Transportation and Storage

During transportation and storage, should avoid water seepage and mechanical damage.

Conditions for operation in service

Where the following conditions apply, fuses complying with this standard are deemed capable of operating satisfactorily without further qualification;

Normal temperature: -5℃ to 40℃;

The altitude of the site of installation of the fuses does not exceed 2 000 m above sea level;

The air is clean and its relative humidity does not exceed 50 % at the maximum temperature of 40℃;

Higher relative humidities are permitted at lower temperatures, e.g. 90 % at 20℃;

Under these conditions, moderate condensation may occasionally occur due to variation in temperature.

For operation condition other than above, please contact manufacturer.

Vibration

Meet UL248-20 Section 8.6.2.3 Vibration Test C requirement, can be use on Electrical Vehicle application.

PROSEMI TECHNOLOGY

SEND A MESSAGE

Feel free to fill out our contact form below and our support team will get back to you within 24 hours.